2.2.4 How to use Hitachi Program Product Installer
Hitachi Program Product Installer is stored in SNMP Agent distribution media. This subsection describes how to start Hitachi Program Product Installer and install SNMP Agent. For details about the Hitachi Program Product Installer, see the Release Notes in the distribution media.
- Organization of this subsection
(1) Starting Hitachi Program Product Installer
The following procedure shows how to start Hitachi Program Product Installer.
Procedure
-
Insert the provided SNMP Agent CD-ROM into the drive.
-
Mount the CD-ROM.
The mounting method depends on the OS, hardware, and environment in use. For details about the mounting method, see the OS documentation.
-
Install Hitachi Program Product Installer and then start it.
The directory and file names in the CD-ROM might be displayed differently depending on the system environment. Use the ls command to check the names and enter the correct file names.
-
Unmount the CD-ROM.
After installation is completed, unmount the CD-ROM. For details about the unmounting method, see the OS documentation.
(2) How to install SNMP Agent
This subsection describes how to install SNMP Agent using Hitachi Program Product Installer.
Execute the following command to start Hitachi Program Product Installer:
/etc/hitachi_setup
When Hitachi Program Product Installer starts, the initial window is displayed.
|
In the initial window, enter I to display a list of the programs that can be installed. Move the cursor to the program you want to install and then press the space bar to select it. Enter I again to install SNMP Agent. After installation is completed, enter Q to return to the initial window.
(3) Removing SNMP Agent
Execute the following command to start Hitachi Program Product Installer:
/etc/hitachi_setup
The initial window of Hitachi Program Product Installer is displayed. For details about the initial window, see Figure 2-2.
In the initial window, enter D to display a list of the programs that can be removed. Move the cursor to the program you want to remove and then press the space bar to select it. Enter D again to remove the software. After the removal process is completed, enter Q to return to the initial window.
(4) Displaying the version information
Execute the following command to start Hitachi Program Product Installer:
/etc/hitachi_setup
The initial window of Hitachi Program Product Installer is displayed. For details about the initial window, see Figure 2-2.
In the initial window, enter L to display a list of the Hitachi products that have been installed.