D.3 Notes on measurement in a firewall/NAT environment
If there is a firewall/NAT between PFM - Agent for Service Response host and the target services for measuring, you need to set the communications that can pass through the firewall/NAT for each target service.
The following table lists how to set the communications that can pass through the firewall/NAT for each target service.
Target service for measuring |
How to set |
Port number |
---|---|---|
|
Set the port numbers for the communication protocol that can pass through the firewall/NAT. |
-- |
TCP |
Set the port numbers for TCP communication specification (IP address, port number) that can pass through the firewall/NAT. |
-- |
|
Set the port numbers for the target Web pages that can pass through the firewall/NAT. |
-- |
User-defined services |
Set the port numbers for the user-defined programs that can pass through the firewall/NAT. |
-- |
- Legend:
-
--: Port numbers vary depending on the target services for measuring.