7.3.8 Replay Report window

The Replay Report window is used to show the replay report of the IE scenario by the Measurement Test. This window appears when the replaying IE scenario is completed.

Figure 7‒38: Replay Report window

The following describes the displayed items.

Replay results of operations

The following shows the information about the result of the replaying an IE scenario.

• Replay Status

  Displays the Replay Status (Succeeded or Failed), File name, Start date, and End data.

• Replay Report Summary

  Displays the Total replay time. The Total replay time is displayed to three places of decimals.

• Scope Summary

  Displays the replayed scopes (scope IDs and scope names) and the Total replay time of the scope.

• Replay Report Details

  Displays the replayed operations (operation number and operation name), Replay time of the scope^#1, Start Scope (scope IDs and scope names^#2), End Scope (scope IDs and scope names^#2), and the number of the tags that match the Filter Conditions. Note that the number of the tags that match the Filter Conditions is displayed only for the HTML operations.

#1

The Replay time is displayed to three places of decimals.

#2

If multiple scopes are specified in one operation, only scope name is displayed.

• Message Information

  Displays the operations where errors occur (operation number and operation name) and the error message information.

To Page Top