2.4.1 Changing the performance data storage destination
Performance data collected by PFM - RM for Virtual Machine is managed in the Store database of the Remote Monitor Store service of PFM - RM for Virtual Machine. This subsection explains how to change the performance data storage destination.
To change the data storage folders listed below that collect performance data managed in the Store database, use the jpcconf db define command to specify a new folder. If you need to save the performance data that was collected before the Store database storage folders were changed, use the -move option of the jpcconf db define command. For details about the jpcconf db define command, see the chapter that explains commands in the manual JP1/Performance Management Reference.
-
Save folder
-
Backup folder
-
Partial backup folder
-
Export folder
-
Import folder
The table below describes the option names and the ranges of values that can be set in the jpcconf db define command.
Explanation |
Option name |
Value that can be set#1 |
Default value#2 |
---|---|---|---|
Performance data creation folder |
sd |
Path name of 1-214 bytes |
installation-folder\agt8\store\instance-name |
Performance data backup folder |
bd |
Path name of 1-211 bytes |
installation-folder\agt8\store\instance-name\backup |
Performance data partial backup folder |
pbd |
Path name of 1-214 bytes |
installation-folder\agt8\store\instance-name\partial |
Largest generation number for saving performance data |
bs |
1-9 |
5 |
Performance data export folder |
dd |
Path name of 1-127 bytes |
installation-folder\agt8\store\instance-name\dump |
Performance data import folder |
id |
Path name of 1-222 bytes |
installation-folder\agt8\store\instance-name\import |
- #1
-
Specify the folder name using a relative or absolute path from the default Store database storage folder (installation-folder\agt8\store).
- #2
-
For the default values when Performance Management is operated on a logical host, replace installation-folder with environment-folder\jp1pc.