KAVJS2835-E
An attempt to change the bind settings of an alarm table has failed.
Agent name: agent-name
Possible causes are as follows:
-
The specified agent or alarm table has been deleted.
-
The number of alarms binding an agent exceeded the maximum.
-
The specified agent does not support alarm notifications of state changes for each instance.
- (S)
-
Changes the bind settings only for agents whose settings can be changed, and then finishes processing.
- (O)
-
Perform the following:
-
Make sure that the alarm table and specified agent exist.
-
Check the agent bound to this alarm table, unbind or delete unnecessary alarms, and then try to change the bind settings of the alarm table again.
-
Check the version of the agent bound to this alarm table, and then try to change the bind settings of the alarm table again.
-