KAVJS2604-E
The service properties could not be updated.
Possible causes are as follows:
-
A service has stopped or a communication error has occurred.
-
The maximum number of nodes that can be added to a service has been exceeded.
-
An agent in the connected PFM - Manager is in the suspended state.
-
A setting value in the application definition is incorrect.
- (S)
-
Suspends processing.
- (O)
-
Check the following:
-
Make sure the operating status and communication status of the service and manager are normal.
-
Make sure the number of property nodes does not exceed the maximum.
-
Make sure that the setting values in the application definition are correct.
-
Use either the Monitoring Suspension Settings window or a command that displays the monitoring suspension settings and monitoring status to check the monitoring status of the agent. If an agent is in the suspended state, resume the monitoring of the agent. If the problem persists, disable the monitoring suspension function.
-