KAVE05092-E
An error occurred so command execution was terminated. (rc=reason-code)
Command execution was terminated because an error occurred. One of the following reason codes is displayed, depending on the situation:
-
When this message is displayed following KAVE05091-E:
1 is displayed as the reason code.
-
When this message is displayed following KAVE05099-E:
The termination code of an internal command is displayed as the reason code.
-
All other cases:
The detail code of the preceding error message is displayed.
- (S)
-
Stops the requested processing.
- (O)
-
Check the error message displayed before this message, correct the cause of the error, and then re-execute the command.