13.2.6 Network settings for JP1/SLM linkage
This subsection describes how to set up port numbers and name resolution for IP addresses to link with JP1/SLM.
- Organization of this subsection
(1) Setting IP addresses
Set host names that can be resolved into an IP address in communications from the JP1/SLM host to the PFM - Manager host, and from PFM - Agent and PFM - RM hosts to the JP1/SLM host. Host names and IP addresses defined in the jpchosts file are checked before the standard name resolution method is applied.
- Note
-
Performance Management supports static NAT with one-to-one IP address mapping.
Dynamic NAT and NAPT (which includes port translation) are not supported.
(2) Setting port numbers
PFM - Manager and JP1/SLM use the port numbers listed in the table below. The port numbers are assigned by default.
If a firewall is installed, the port numbers in Table 13-3 Port numbers for JP1/SLM linkage must be open. If the port number being used varies according to a setting in the httpsd.conf file or in JP1/SLM, set that port number so that it is open on the firewall.
For details on how to set port numbers, see the chapter that describes changing the network configuration in the JP1/Performance Management Planning and Configuration Guide.
The following table lists the available port numbers for JP1/SLM linkage and their purpose.
Purpose |
Port number |
Direction of traffic |
---|---|---|
For setting up JP1/SLM linkage. Used by the ViewServer service of PFM - Manager. |
22286 |
From JP1/SLM host to PFM - Manager host |
For starting PFM - Web Console from JP1/SLM. Used by the Web Service service of PFM - Web Console. |
20358 |
From Web browser to PFM - Web Console host |
For receiving performance data on the JP1/SLM host. Set on the JP1/SLM host. |
20905 |
From PFM - Agent and PFM - RM hosts to JP1/SLM host |