10.2.4 Installing an upgrade for PFM - Agent or PFM - RM
To install an upgrade for PFM - Agent or PFM - RM in a physical host environment where PFM - Agent, PFM - RM, or PFM - Manager is running in a logical host environment:
-
Use the cluster software to stop all of the PFM services on each logical host.
-
Use the jpcspm stop -key jp1pc command to stop all of the PFM services on both the executing and standby physical hosts.
-
Place the shared disk online from the executing node.
-
Install PFM - Agent or PFM - RM on each applicable executing host by overwriting the previous installation.
-
Install PFM - Agent or PFM - RM on each applicable standby host by overwriting the previous installation.
-
Set up Performance Management so that it can run.
-
Use the cluster software to start all of the PFM services on each logical host.
-
Use the cluster software to start all of the PFM services on both the executing and standby physical hosts.
For details on PFM - Agent-specific or PFM - RM-specific considerations, see the corresponding PFM - Agent or PFM - RM manual and the Release Notes.