8.4.2 Changing from the master/slave configuration to the single-manager configuration

This section explains how to change from the master/slave configuration to the single-manager configuration.

Organization of this subsection

(1) Procedure

Procedure

Use the jslmmgrexport command to export the data of monitored services from the master and slave instances of SLM - Manager in the master/slave configuration, to be inherited by an instance of SLM - Manager in the single-manager configuration.

For details about the
jslmmgrexport
command, see
9.9 jslmmgrexport (exports service monitor information)
in
9. Commands
.
Perform an unsetup of all instances of SLM - Manager (master and slave) in the master/slave configuration.
To prevent the properties file from the time of the master/slave configuration from being inherited, delete the following system definition file.

SLM-Manager-installation-folder\mgr\conf\jp1itslm.properties
Creates a setup options file for the single-manager configuration.

For details about the setup options file, see 9.12 jslmmgrsetup (sets up SLM - Manager) in 9. Commands.
Set up SLM - Manager to the single-manager configuration.
Set up SLM - UR again to match the configuration of SLM - Manager.
Import the data exported in step 1 into the instance of SLM - Manager that was set up in steps 3 and 4.

When the IP address of SLM - UR has been changed, make changes with the -m option of the jslmmgrimport command when importing data.

For details about the jslmmgrimport command, see 9.10 jslmmgrimport (imports service monitor information) in 9. Commands.