6.2.7 Setting up the logical host in the active system (SLM - UR)
You set up SLM - UR as the logical host in the active system.
You can set up either SLM - UR first or SLM - Manager first.
- Organization of this subsection
(1) Before you start
Before you start the setup, install the SLM - UR that is to be set up.
For details about how to install SLM, see 6.2.5 Installing SLM.
Verify that the following Windows service is stopped:
SLM - UR service SLM - User Response Service (service name: JP1_ITSLM_UR_Service)
The other items to be verified are the same as when SLM is run in a non-cluster system; for details, see 5.1.7 Setting up SLM - UR.
(2) Procedure
To set up the logical host in the active system:
Execute the command for checking the network interface number and IP address of the host on which SLM - UR has been installed.
Execute the following command:
SLM-UR-installation-folder\ur\bin\jslmuripls
For details about the command for checking the network interface number and IP address, see 9.17 jslmuripls (displays network interface number and IP address) in 9. Commands.
Create the options file required for setup based on the information checked by executing the jslmuripls command.
For details about the options file, see 9.19 jslmursetup (sets up SLM - UR) in 9. Commands.
Store the created options file in a desired folder.
Make sure that the absolute path of the options file storage location does not exceed 255 bytes including the options file name (any name).
Execute the setup command.
The following shows the setup command that is to be executed:
SLM-UR-installation-folder\ur\bin\jslmursetup -c online absolute-path-of-options-file
For details about the setup command, see 9.19 jslmursetup (sets up SLM - UR) in 9. Commands.
If the command terminates normally, SLM - UR has been set up to be used as the logical host in the active system.
(3) Supplementary information
The supplementary information is the same as when SLM is run in a non-cluster system; for details, see 5.1.7 Setting up SLM - UR.