3.12.2 User authentication for sending emails
JP1/Service Support supports the following user authentication methods that can be used when sending emails:
-
POP before SMTP
-
SMTP Authentication (PLAIN and LOGIN)
-
No user authentication
In the email definition file, specify settings (including whether to perform user authentication when sending an email and the address of the mail server required for the user authentication) beforehand. Note that the user ID and password for user authentication must be set in the email definition file by executing the jssauthusersetup (authentication user setup) command. For details about the email definition file, see Email definition file (jp1imss_mail_setting.conf) in Chapter 13. Definition Files. For details about the jssauthusersetup command. see jssauthusersetup (authentication-user setting) in Chapter 12. Commands.