2.4.1 Executing the setup command
After you have installed JP1/IM - EG for NNMi, you execute the setup command (jegn_setup) to set up an operating environment for JP1/IM - EG for NNMi.
For details about the jegn_setup command, see jegn_setup in 7. Commands.
The following table lists and describes the information that is set by the jegn_setup command.
Item |
Description |
Setting |
---|---|---|
NNMi user name |
Sets the user name of the Web service client# of NNMi. |
Y |
NNMi password |
Sets the password of the Web service client# of NNMi. |
Y |
NNMi port number |
Sets the port number of the NNMi that is to be connected. |
-- |
NNMi language |
Sets the language of the NNMi that is to be connected. |
-- |
NNMi incident re-acquisition interval |
Sets the interval at which another attempt is to be made to acquire NNMi incidents when there are no NNMi incidents to be acquired or in the event of an exception such as a communication error. |
-- |
NNMi incident acquisition method |
Sets the first NNMi incident to be acquired in cases where NNMi incidents issued while the JP1/IM - EG for NNMi services are stopped are to be acquired the next time the services start (except during the initial start). |
-- |
Availability of SSL |
Sets whether SSL is to be used when NNMi is connected. |
-- |