7.3 Installing and setting up logical hosts (new installation and setup) (for UNIX)
This subsection describes new installation and setup of a logical host for JP1/IM - Manager. It also describes the setup of JP1/Base because JP1/Base must be set up on the same logical host.
Before you start the procedure, check the following information about the cluster system.
Item to be checked |
Description |
---|---|
Logical host name |
Name of the logical host that executes JP1 |
Logical IP address |
IP address that corresponds to the logical host name |
Shared directory |
Folder on the shared disk that stores a set of files for the JP1 execution environment on the logical host |
Additionally, make sure that these items satisfy the prerequisites described in 6.1.2 Prerequisites for cluster operation (for Windows).
Once you have finished checking the above items, you are ready to start the installation and setup.
Note that logical host names are case sensitive. Specify the logical host names set in JP1/Base in the correct form, including case. If you installed and set up the logical host after specifying an incorrect logical host name, delete the IM databases and the logical host, and then install and set up the logical host again. For details about how to delete the IM databases and logical hosts, see 7.6.1 Deleting logical hosts (for UNIX).
- Organization of this section
-
-
7.3.1 Newly installing JP1/Base and JP1/IM - Manager (for UNIX)
-
7.3.2 Setting up the physical host environment during new installation (for UNIX)
-
7.3.3 Setting up the logical host environment (primary node) during new installation (for UNIX)
-
7.3.4 Copying the common definition information during new installation (for UNIX)
-
7.3.5 Setting up the logical host environment (secondary node) during new installation (for UNIX)
-