6.7.1 Changing settings in files (for Windows)
If you have edited the files listed below and used the jbssetcnf command to apply the settings, you must copy the common definition information from the primary server to the secondary server:
-
Automated action environment definition file (action.conf.update)
-
Communication environment definition file (console.conf.update)
-
Settings file for the maximum number of status change events (evhist_warn_event_xxx.conf)
-
Settings file for completed-action linkage function (action_complete_xxx.conf)
-
Definition file for automatic delete mode of status change event
-
Definition file for monitoring object initialization mode
-
Automatic backup and recovery settings file for monitoring object database (auto_dbbackup_xxx.conf)
-
Correlation event generation environment definition file
-
Definition file for on memory mode of status change condition
-
Apply-IM-configuration-method definition file (jp1cf_applyconfig.conf)
-
Remote log trap environment definition file (jp1cf_remote_logtrap.conf)
-
Environment definition file for events after the display message is changed (chmsgevent.conf)
-
Environment definition file for event report output (evtreport.conf)
-
Operation log definition file (imm_operationlog.conf)
-
Profile management environment definition file (jp1cf_profile_manager.conf)
Copy the common definition information using the setup procedure described in 6.3.4 Copying the common definition information during new installation (for Windows).
The common definition information contains settings for JP1/Base, JP1/IM - Manager, JP1/AJS, and JP1/Power Monitor (06-02 or later). If these products have been set up on the logical host, the settings are also copied.