2. Installation and Setup (for UNIX)

Organization of this chapter

• 2.1 Installation and setup procedures (for UNIX)

• 2.2 Preparations required before installation (for UNIX)

• 2.3 Installing JP1/IM - Manager (for UNIX)

• 2.4 Creating IM databases (for UNIX)

• 2.5 Setting up user authentication and user mapping (for UNIX)

• 2.6 Specifying settings for handling JP1/Base failures (for UNIX)

• 2.7 Setting the system hierarchy (when IM Configuration Management is used) (for UNIX)

• 2.8 Setting the system hierarchy (when IM Configuration Management is not used) (for UNIX)

• 2.9 Setting up Event Service (for UNIX)

• 2.10 Setting JP1 event forwarding when IM Configuration Management is used (for UNIX)

• 2.11 Setting JP1 event forwarding when IM Configuration Management is not used (for UNIX)

• 2.12 Collecting and distributing Event Service definition information when IM Configuration Management is used (for UNIX)

• 2.13 Collecting and distributing Event Service definition information when IM Configuration Management is not used (for UNIX)

• 2.14 Setting up a command execution environment (for UNIX)

• 2.15 Specifying settings for using the source host name of Event Service in the FQDN format (for UNIX)

• 2.16 Specifying settings for monitoring logs on remotely monitored hosts (for UNIX)

• 2.17 Setting up JP1/IM - Manager (for UNIX)

• 2.18 Saving manuals to a computer (for UNIX)

• 2.19 Uninstallation (for UNIX)

To Page Top