Executing commands
To execute JP1/ITDM2 - SDM commands, you can use the Windows command prompt. The following describes how to execute a command.
- Organization of this page
Executing commands
-
Open the Windows command prompt.
-
Change the current directory to the command storage location.
The command is stored in the following locations:
Server type
Storage location
Smart device manager
JP1/ITDM2 - SDM (Smart Device Manager)-installation-folder\mgr\bin
Communication server
JP1/ITDM2 - SDM (Communication Server)-installation-folder\cms\bin
Messaging server
JP1/ITDM2 - SDM (Messaging Server)-installation-folder\mss\bin
-
Enter the command that you want to execute.