6.1.1 Setting automatic action by JP1/IM - Manager
This section explains the settings for automatic collection by JP1/IM - Manager of JP1 events issued by Asset Console. It also explains the settings for notifying JP1/IM -Manager of problem resolution by Asset Console.
- Organization of this subsection
(1) Setting automatic collection of JP1 events
The figure below shows a specification example for notifying Asset Console of only emergencies and warnings from the information displayed on the JP1/IM side.
The following describes the values to be specified in JP1/IM - Manager's Action Parameter Detailed Definitions dialog box.
-
Leave the Parameter group settings unchanged.
-
For Action name, specify a desired name.
-
For Comment, enter a comment as necessary.
-
Action Condition tab (Condition)
-
For Event ID, select All IDs.
-
In Event conditions, click the Add button, and select Importance. Then select the Emergency and Warning check boxes in Specify directly, and click the Apply button.
-
-
Action Condition tab (Action Definition)
-
For Execution user name, specify the name of the user who executes actions.
-
For Target host, specify the name of the host that executes actions.
-
For Action, specify jamTakeIMEvent.bat "$EVDATE" "$EVTIME" "$EVUSR" "$EVHOST" "$EVIPADDR" "$EVSEQNO" "$EVMSG" "$EVSEV" "$ACTHOST" "$EV"OBJECT_TYPE"" "$EV"SNMP_SOURCE"".
Do not express a file name as a path.
-
Leave Environment variable file blank.
-
-
Execution monitoring tab
Specify the settings as needed.
(2) Setting error completion notification
When you register a resolution to a problem in Asset Console, you must set the JP1/IM - Manager jcochstat command for automatic notification to notify JP1/IM - Manager that the problem has been resolved.
The following shows the value specified in the JP1/IM - Manager Action Parameter Detailed Definitions dialog box.
-
Specify the Parameter group settings different from the setting in (1).
-
For Action name, specify a desired name.
-
For Comment, enter a comment as necessary.
-
Action Condition tab (Condition)
-
Select Specify ID for Event ID, and specify 00005581.
-
Leave Event conditions blank.
-
-
Action Condition tab(Action Definition)
-
Specify the user name to execute actions in Execution user name.
-
Specify the host name to execute actions in Target host.
-
Specify the full path to the jcochstat command in Action and -n "$EV"EVENT_SEQNO"" -k PROCESSED.
-
Leave Environment variable file blank.
-
-
Execution monitoring tab
Specify the settings as needed.
To reflect the JP1 event or SNMP trap resolution status changed by Asset Console, select the Resolution status change approval check box for the jcochstat command on the Communication tab of the System Environment Settings dialog box.