4.1.6 Procedure for changing agent monitoring items
You can use an inventory settings file (jdng_inventory.conf) to change the items that are subject to regular monitoring on computers with the agent software installed.
To change the monitored items for agents:
-
Using a text editor, create an inventory settings file (jdng_inventory.conf) with the content shown in the table below, and place it in the %ALLUSERSPROFILE%\HITACHI\jp1itdma\conf folder.
Section
Key name
Description
Setting values
Default setting
SystemInventory
DHCPLeaseExpires
You can specify whether to monitor for changes in the DHCP lease expiry time.
If this section or key is omitted or the specified value is invalid, the system operates as if 0 were specified.
-
0: Do not monitor
-
1: Monitor
0
DHCPLeaseObtained
You can specify whether to monitor for changes in the time of obtaining the DHCP lease.
If this section or key is omitted or the specified value is invalid, the system operates as if 0 were specified.
-
0: Do not monitor
-
1: Monitor
0
-
The changes to the monitored items for agents take effect.
The following is an example of an inventory settings file that specifies the expiration and acquisition dates and times of DHCP leases as items to be monitored. The monitoring interval is the value specified in Monitoring Interval (Others) (min) in the Timing of communication with the higher system area on the Basic Settings page during agent setup.
[SystemInventory] DHCPLeaseExpires=1 DHCPLeaseObtained=1
The content of the inventory settings file automatically takes effect when device information is next acquired from the agent.