4.1.1 Installation procedure
To install JP1/IT Desktop Management 2, you must design a system configuration and set up an environment. The following describes the installation procedure for JP1/IT Desktop Management 2.
-
Examine the organization rules
Examine the security control rules for the organization. You can design, set up, and operate the JP1/IT Desktop Management 2 system based on the examination results.
-
Check the system prerequisites
Check the prerequisites for the servers and computers in the system. For details about checking the prerequisites, see 4.2 System prerequisites.
-
Examine the system configuration
Examine the system configuration considering the purpose of the system. For details about examining system configurations, see 4.4 Examining the system configuration.
-
Examine the functions to use
Confirm that the operating environment satisfies the prerequisites for the functions to be used. For details about the prerequisites for each function, see 4.3 Prerequisites for functions.
-
Analysis and preparation before operation
Examine the system operation methods, including the devices to be managed and the operation schedule. For details about examining operation methods, see 4.6 Analysis and Preparation before operation.
-
Examine the database
Consider what database size is appropriate for the operation method. For details about examining a database, see 4.5 Examining the database.
-
Estimate the system requirements
Based on the results in steps 1 to 6, estimate the requirements of the system. For details about estimating system requirements, see A.6 Performance and Estimates.
For details about the system operation procedure, see 4.1.2 Operation procedure.