2.15.1 Events to be output
An event is output if something occurs (for example, a device is detected, an asset is registered, or judgment based on a security policy is performed) while JP1/IT Desktop Management 2 is running. You can check the output event in Events module.
Events are divided into three severities depending on the details.
(Critical)
-
Events that require immediate action. Check the details of the event, and take action immediately.
(Warning)
-
Events that require a response but not immediately. Check the details of the event, and take action as necessary.
(Information)
-
Events regarding the results of system processing. No actions are required.
Some events require immediate action. Check Critical events first and then Warning events. Determine the cause referring to the error message, and take appropriate actions. You can check the total number of events and the number of individual types of events on the Not Ack Event Summary panel of the Home module. You can also check the number of unconfirmed events in Summary Reports.
You can set for the administrator to be notified of events when they occur.
- Tip
-
The maximum number of events to be displayed can be calculated by the following formula: number-of-owned-product-licenses x 250 + 10,000. If the number of events exceeds this value, older evens will be overwritten. Back up past events to save them.
Related Topics: