2.8.5 Changing the network access control agent
If a change of circumstances such as the replacement or repurposing of hardware means that you need to change the computer on which the network monitor is enabled, disable the network monitor and then enable it on another computer.
To change the network access control agent:
-
Disable the network monitor.
When you disable the network monitor, the network monitor agent is uninstalled from the computer and the operating status appears as Non-management in the menu area. At this time, monitoring of the network temporarily stops.
-
Enable the network monitor.
After the network monitor is disabled, enable the network monitor on the computer that you want to use as the network access control agent.
After enabling the network monitor on a computer, you can monitor the network segment where the computer is located.