7.2.15 Edit Output Filter dialog box
Use the Edit Output Filter dialog box to set an output filter. An output filter is a regular expression used to extract the value to be set as an output property from the standard output value or the standard error output value. To display the Edit Output Filter dialog box, in the Edit Remote Command dialog box, click the Edit button in the Mapping Definition of Output Properties section.
This dialog box displays the following items:
- Key
-
Shows the property key of the output property.
- Name
-
Shows the name of the output property.
- Description
-
Shows a brief description of the output property.
- Output Filter text box
-
Enter an output filter. The text box allows a maximum of 1,024 characters. Specify a regular expression that conforms to PCRE.
- Verification of the Output Filter
-
If you click this, the Standard Output / Standard Error Output text box, the Verification of the Output Filter button, and the Value of the Output Property display area are displayed.
- Standard Output / Standard Error Output text box
-
Enter test data to be used for verification of the specified output filter. The text box allows a maximum of 500,000 characters.
- Verification of the Output Filter button
-
If you click this button, verification of the output filter starts, using the data entered in the Standard Output / Standard Error Output text box.
- Value of the Output Property display area
-
Displays the result of verification of the output filter.
- OK button
-
Click this button to apply the changes.
- Cancel button
-
Click this button to close the Edit Output Filter dialog box.