9.6 Deleting a logical host from a cluster environment

To remove a logical host for JP1/IM - Service Support from a cluster environment:

1. Switch the active node from the primary node to secondary node.

   Use the cluster software to switch the nodes.

2. On the secondary node, use the cluster software to delete registered services.

3. On the secondary node, perform unsetup of the logical host.

   From the Start menu, select Programs, JP1_Integrated Management - Service Support, and then JP1_IM-SS Command Prompt. Execute the jsshaunsetup.bat command. For details about the jsshaunsetup.bat command, see jsshaunsetup.bat (performs unsetup of JP1/IM - Service Support in a cluster environment) in Chapter 11. Commands.

4. Switch the active node from the secondary node to primary node.

   Use the cluster software to switch the nodes.

5. On the primary node, perform unsetup of the logical host.

   From the Start menu, select Programs, JP1_Integrated Management - Service Support, and then JP1_IM-SS Command Prompt. Execute the jsshaunsetup.bat command. For details about the jsshaunsetup.bat command, see jsshaunsetup.bat (performs unsetup of JP1/IM - Service Support in a cluster environment) in Chapter 11. Commands.

6. Use the cluster software to delete registered resources.

   This step is not necessary when you reuse resources.

To Page Top