6.4.3 Setup procedure for repair installation
Use this procedure to set up JP1/IM - Service Support after a repair installation. This procedure is the same for all JP1/IM - Service Support products.
-
Execute the jsssetup.bat command.
From the Start menu, select Programs, JP1_Integrated Management - Service Support, and then JP1_IM-SS Command Prompt, and execute the jsssetup.bat command with the -r option specified as an argument to set up JP1/IM - Service Support.
For details about the jsssetup.bat command, see jsssetup.bat (sets up JP1/IM - Service Support) in Chapter 11. Commands.
-
Execute the jsschauthorityserver command.
If you used an LDAP server as the authentication server, or if you used the authentication function of JP1/Base, the Item management database server becomes the authentication server. Execute the jsschauthorityserver command to switch the authentication server. This procedure is not necessary if you did not use an LDAP server as the authentication server, or if you did not use the authentication function of JP1/Base.
For details about the jsschauthorityserver command, see jsschauthorityserver (switches the authentication method) in Chapter 11. Commands.
-
Execute the jssdbbackup.bat command.
Execute the jssdbbackup.bat command with the -maint option specified as an argument to back up the new environment.
For details on the jssdbbackup.bat command, see jssdbbackup.bat (backs up databases) in Chapter 11. Commands.