6.3.1 New installation procedure
The following describes the procedure for new installation of JP1/IM - Service Support. There are two types of new installation:
-
New installation using the distribution media
-
Remote installation using JP1/Software Distribution
These procedures are respectively described below. Administrator permissions are required to perform these procedures. These procedures are the same for all JP1/IM - Service Support products.
- Organization of this subsection
(1) New installation using the distribution media
To perform new installation of JP1/IM - Service Support by using the distribution media:
-
Insert the distribution media into the drive, and install JP1/IM - Service Support.
Perform installation according to the directions of the installer which starts automatically.
Specify the following settings:
-
Use information
-
Installation-destination folder
The JP1SS folder is created in the specified installation-destination folder, and this product is installed in the JP1SS folder. Specify the absolute path to the installation-destination folder in no more than 38 bytes.
You can use half-width alphanumeric characters and symbols except the following symbols: comma (,), semicolon (;), asterisk (*), question mark (?), double quotation mark ("), left angle bracket (<), right angle bracket (>), vertical bar (|), dollar sign ($), percent sign (%), ampersand (&), single quotation mark ('), grave accent mark (`), forward slash (/), caret (^), exclamation mark (!), hash mark (#), left curly bracket ({), right curly bracket (}), left square bracket ([), right square bracket (]), plus sign (+), minus sign (-), equal sign (=), at mark (@), swung dash (~), colon (:), and yen sign (\\).
The default path is system-drive:\Program files\Hitachi\JP1SS.
-
Program folder name displayed in the Start menu
The default name is JP1_Integrated Management - Service Support.
-
-
If requested, restart the operating system.
- Reference note
-
Installing JP1/IM - Service Support registers the following in the Start menu:
-
JP1_IM-SS Command Prompt
-
JP1_IM-SS Login
-
(2) Remote installation using JP1/Software Distribution
JP1/IM - Service Support supports remote installation (software distribution) using JP1/Software Distribution. For details about how to actually perform remote installation using JP1/Software Distribution, see the Job Management Partner 1/Software Distribution Administrator's Guide Volume 1(For Windows Systems).