6.1 Flow of installation and setup
There are two types of installation: new installation and overwrite installation. New installation installs JP1/IM - Service Support on a machine on which JP1/IM - Service Support has not yet been installed. Overwrite installation installs JP1/IM - Service Support on a machine on which JP1/IM - Service Support has already been installed.
The following describes the flow of installation and setup of JP1/IM - Service Support for each type of installation.
- New installation
-
This installs JP1/IM - Service Support on a machine on which JP1/IM - Service Support has not yet been installed. The following figure shows the flow of new installation and setup.
Figure 6‒1: Flow of new installation and setup - Overwrite installation
-
This installs JP1/IM - Service Support on a machine on which JP1/IM - Service Support has already been installed. There are two types of overwrite installation:
-
Version upgrade installation
This installs JP1/IM - Service Support 10-50 on a machine on which an earlier version of JP1/IM - Service Support is installed.
-
Repair installation
This installs either a corrected version or the same version of JP1/IM - Service Support 10-50 program on a machine on which JP1/IM - Service Support 10-50 has already been installed.
- upgrade
-
-
product upgrade meaning
-
version upgrade meaning
-
The following figures show the flow of version upgrade installation and setup and the flow of repair installation and setup.
Figure 6‒2: Flow of version upgrade installation and setup Figure 6‒3: Flow of repair installation and setup -
- Performing a product upgrade of JP1/IM - Service Support
-
You can perform a product upgrade of JP1/IM - Service Support (Standard) to JP1/IM - Service Support Advanced Edition. The machine on which you install JP1/IM - Service Support Advanced Edition must be running one of the following operating systems:
-
Windows Server 2003 (x64)
-
Windows Server 2008 R2
-
Windows Server 2008 (x64)
-
Windows Server 2012
For details on product upgrades of JP1/IM - Service Support, see 6.6 Performing a product upgrade of JP1/IM - Service Support.
-
For details about new installation and setup in a cluster environment, see 9.2 Setting an environment for cluster use (environment configuration after new installation). For details about version upgrade installation and setup in a cluster environment, see 9.8 Version upgrade in a cluster environment.
- Note:
-
JP1/IM - Service Support (Standard) means the following JP1/IM - Service Support product:
-
JP1/IM - Service Support 10-10
-