3.19 JP1/IM - Service Support services
JP1/IM - Service Support consists of four services. The following figure shows the relationship among these services.
When JP1/IM - Service Support is installed, these services are registered in the Services dialog box of Windows Server 2012,
Windows Server 2008, or Windows Server 2003. The following table lists and describes the services.
Table 3‒51: JP1/IM - Service Support services
Display name
|
Service name
|
Startup type
|
Description
|
JP1/Service Support
|
JP1_Service Support
|
Manual
|
A WWW container server. The JP1/IM - Service Support internal component that controls window display.
This service and JP1/Service Support - Web Service are mutually dependent.
This service is required to operate JP1/IM - Service Support from an Item management console.
|
JP1/Service Support - Web Service
|
JP1_Service Support-WebService
|
Manual
|
A Web server. The JP1/IM - Service Support internal component that interfaces with Item management consoles (web browsers).
This service is required to operate JP1/IM - Service Support from an Item management console.
|
JP1/Service Support - DB Server
|
HiRDBEmbeddedEdition_JSO
|
Automatic
|
The Item management database server. The JP1/IM - Service Support internal component that manages the Item management database.
This service updates the contents of the Item management and Item storage databases in response to operations from Item management
consoles or processing requests from commands.
|
JP1/Service Support - Task Service
|
JP1_ServiceSupport-TaskService
|
Manual
|
A service for executing the following commands at specified times or intervals:
-
jsscollectdata (counts Item information)
-
jssinformperiod (notifies of closing deadlines)
-
jssinformleave (sends reminders about held Items)
-
jssitementrybymail (registers emails as Items)
This service is required to accumulate Item information, enable pre-deadline notification, report unprocessed Items, or register
Items via email.#
|
Note that to operate JP1/IM - Service Support, you must activate the following service, which is a common service used by
JP1 products:
-
Hitachi Network Objectplaza Trace Monitor 2
When JP1/IM - Service Support is installed, Hitachi Network Objectplaza Trace Monitor 2 is also registered with the startup
type of Automatic in the Services dialog box of Windows Server 2012, Windows Server 2008, or Windows Server 2003.
- Important note
-
In addition to the above services, the JP1/Service Support - DB Cluster Service is also registered in the Services dialog
box of Windows Server 2012, Windows Server 2008, or Windows Server 2003 when JP1/IM - Service Support is installed. This service
is used only when JP1/IM - Service Support is used in a cluster system.
To Page Top