PERMISSION_SPOOLJOB_DIR parameter (defines permission for the spool job directory) (UNIX only)
- Organization of this page
Format
#-adsh_conf PERMISSION_SPOOLJOB_DIR permission
Description
This parameter defines the new permission when the permission for the spool job directory is to be changed when the job terminates.
If this parameter is not specified, the permission for the spool job directory is 0700.
Operands
Notes
-
If any of the following is specified for this parameter in an environment file, the job will terminate in an error without being executed:
-
This parameter is specified more than once.
-
No operand is specified.
-
More than two operands are specified.
-
A non-octal number or a value exceeding the value that can be specified for a permission is specified.
-
A value that is not four digits in length is specified.
-
-
If this parameter is defined in both the system environment file and the job environment file, the definition in the job environment file takes effect.
Example
-
This example sets the spool job directory permission to 0750:
#-adsh_conf PERMISSION_SPOOLJOB_DIR 0750