If there is a firewall between PFM - Manager and PFM - Agent for Service Response, you must set fixed port numbers for all services of PFM - Manager and PFM - Agent. To enable communications to all services to pass through the firewall, the port numbers that you set must comply with the directions shown in the following table.

Table D-2 Firewall passage directions (between PFM - Manager and PFM - Agent)

Service name	Parameter	Passage directions
Agent Store service	jp1pcstov	Agent Manager
Agent Collector service	jp1pcagtv	Agent Manager

Legend:

Manager: PFM - Manager host

Agent: PFM - Agent host

: Direction in which communication (connection) begins, from the right-hand item to the left-hand item.

When communication (connection) is initiated, the receiving side (the side indicated by the tip of the arrow) uses the port numbers shown in Table D-1 as receiving ports. The connecting side uses the free port numbers assigned by the OS as sending ports. The available range of port numbers depends on the OS.

Set the firewall so that the sending ports temporarily used by Manager can pass through to the receiving ports of Agent.

Note:

To execute the jcptool db dump (jpcctrl dump) command or jcptool service list (jpcctrl list) command on a PFM - Agent host, use one of the following methods:

• Specify the proxy option of the jcptool db dump (jpcctrl dump) or jcptool service list (jpcctrl list) command to communicate through PFM - Manager. For details about the proxy option of the jcptool db dump (jpcctrl dump) or jcptool service list (jpcctrl list) command, see the chapter that describes commands in the manual Job Management Partner 1/Performance Management Reference.
• Between each PFM - Agent host, set port numbers in the directions shown in the table below so that communication can pass through the firewall.
  

  Table D-3 Firewall passage directions (between PFM - Agent hosts)

  Service name	Parameter	Passage directions
  Agent Store service	jp1pcstov	Agent Agent
  Agent Collector service	jp1pcagtv	Agent Agent

Legend:

Agent: PFM - Agent host

: Directions in which communication (connections) begin: from the left-hand item to the right-hand item, and from the right-hand item to the left-hand item.

If there is a firewall between PFM - Manager and PFM - Agent for Service Response, you must set fixed port numbers for all services of PFM - Manager and PFM - Agent. To enable communications to all services to pass through the firewall, the port numbers that you set must comply with the directions shown in the following table.

Table D-4 Firewall passage directions (between PFM - Manager and PFM - Agent (for logical host operation))

Service name	Parameter	Passage directions
Agent Store service (logical host)	jp1pcstov	Agent (logical host) Manager
Agent Collector service (logical host)	jp1pcagtv	Agent (logical host) Manager

Legend:

Manager: PFM - Manager host

Agent (logical host): PFM - Agent host

: Direction in which communication (connection) begins, from the right-hand item to the left-hand item.

When communication (connection) is initiated, the receiving side (the side indicated by the tip of the arrow) uses the port numbers shown in Table D-1 as receiving ports. The connecting side uses the free port numbers assigned by the OS as sending ports. The available range of port numbers depends on the OS.

When a connection is initiated from Manager to Agent as shown above, set the firewall so that the sending ports temporarily used by Manager can pass through to the receiving ports of Agent.