The following table shows the differences in functionality between how past versions collected information about the application operating status and how version 10-00 collects information about the operating status of processes.

Table 5-2 Differences from previous versions in the collection of information about the operating status of processes

Functionality	Collection of information about the application operating status in versions 09-00 and earlier	Collection of information about the operating status of processes beginning with version 10-00
Acquisition of command line	No	Yes
Maximum value for a command line that can be acquired	--	4,096 bytes
Collection of performance information for specific processes or services	No#1	Yes#2
Maximum value for monitoring conditions that can be specified	127 bytes	4,096 bytes
Maximum value for monitoring conditions that can be displayed in PFM - Web Console	31 bytes	4,096 bytes
Case sensitivity of monitoring targets	No	Yes#3
Identifying monitoring conditions by label	No	Yes#4
Grouping targets when setting process monitoring	Programs (Program) Services (Service Name)	Programs (Program Name) Command line (Command Line) Services (Service Name)

Legend:

Yes: Can be executed.

No: Cannot be executed.

--: Not applicable.

#1

Always collects performance information for all processes or services.

#2

Collects performance information only for the processes or services for which process monitoring has been set.

#3

By default, letter case is not distinguished. For details, see 5.6.7 Distinguishing the letter case of monitoring targets.

#4

Use the MonitoringXX Label field to identify a process or service.

You can use the jpcappcvt command to upgrade application definitions that were set in version 09-00 or earlier to application definitions for version 10-00. For details about the jpcappcvt command, see 8. Commands.

Reference note

There is no need to upgrade application definitions that were set in version 09-00 or earlier if they are not being extended into version 10-00.