24.5.9 Event correlation: ScheduledMaintenance
With NNMi, you can suppress the monitoring of unusable nodes. To do this, use the Out of Service mode. Unlike with NNM, you cannot pre-schedule Out of Service maintenance. You must manually return the object to the Enable ICMP Fault Polling mode.
- Reference note
-
NNMi suppresses SNMP traps sent from devices that are in the Out of Service mode.
If your organization is using ScheduledMaintenance correlation, you can use a list of systems that will go offline together.
-
Check whether ScheduledMaintenance correlation is used in NNM.
-
In the NNMi console, from the Configuration workspace, choose Object Groups > Node Groups.
-
Create a node group for each node set in the NNM maintenance list. Configure the node groups so that they can be used as view filters.
-
For maintenance, from the Inventory workspace in the NNMi console, choose Nodes.
-
To filter the view for a given node group, use the Node Group Filter Configuration selector at the top of the window.
-
Select all nodes, and then choose Actions, Management Mode, and Out of Service.
-
After the maintenance has been completed, select a node, and then choose Actions, Management Mode, and Manage.