24.4.1 Specifying a polling interval
- NNM netmon polling process
-
![[Figure]](GRAPHICS/ZUN00200.GIF)
From the NNM user interface, acquire a polling interval.
- NNMi polling process
-
![[Figure]](GRAPHICS/ZUN00300.GIF)
The NNMi status monitoring configuration is based on node groups or interface groups (or both).
In the NNMi console, from the Configuration workspace, choose Monitoring > Monitoring Configuration. Click the Node Group Settings tab and set Fault Polling Interval.
![[Figure]](GRAPHICS/ZUS11090.GIF)
![[Figure]](GRAPHICS/ZUS11100.GIF)