17.3.1 Notes about using related products
Note the following when you use an NNMi-related product (such as Job Management Partner 1/Consolidated Management 2/SNMP System Observer (JP1/Cm2/SSO)):
-
Set up NNMi first, and then set up the related product.
-
Register NNMi and the JP1/Cm2/SSO related product into the same resource group.
The resource dependency that is set in the cluster software must be as follows:
-
For JP1/Cm2/SSO, set the dependency so that NNMi is required.
-
For NNMi, set the dependency so that the shared disk and virtual IP address are required.
Configure the package that is registered to HP Serviceguard as follows:
-
Add the commands for starting, terminating, and monitoring the related product to the package for NNMi.
-
Add the start command to the customer_defined_run_cmds section in the package control script resource-group.cntl. Make sure that NNMi starts before the related product.
-
Add the termination command to the customer_defined_halt_cmds section of the package control script resource-group.cntl. Make sure that NNMi terminates after the related product.
-
For the monitoring command, edit the monitoring script resource-group.mon and then add that script.
-
For details about how to configure related products, see the applicable documentation, Release Notes, and instruction manuals.