13.11.4 Synchronizing regional manager discovery from a global manager
If you notice an information inconsistency between global1 and regional2, you can fix it by running the nnmnoderediscover.ovpl script from global1, causing global1 and regional2 to synchronize. This also results in regional2 updating global1 with any new discovery results.
Consider the network shown in Figure 13-2 Status polling or configuration polling a node. Suppose you want regional2 to synchronize its entire set of nodes (nodes X, Y, and Z) with global1. Run the following command to synchronize nodes X, Y, and Z with global1:
nnmnoderediscover.ovpl -u username -p password -rm regional2
For details, see the nnmnoderediscover.ovpl Reference Page.
Note the following:
-
NNMi automatically resynchronizes topology, state, and status following a manual resynchronization.