13.8 Reviewing global1 inventory
Do not complete this section until NNMi completes a good discovery. For details, see 4.3.3 Checking discovery progress in the manual Job Management Partner 1/Consolidated Management 2/Network Node Manager i Installation Guide.
To view the node information regional1 has forwarded to global1, complete the following steps:
-
From the global1 NNMi console, navigate to the Nodes by Management Server form located in the Inventory workspace.
![[Figure]](GRAPHICS/ZU510290.GIF)
-
Assume that regional1 passed information about switch node102130 to global1.
After selecting regional1, the inventory might look as follows:
![[Figure]](GRAPHICS/ZU510300.GIF)
Repeat steps 1 through 2 to view the device inventory passed to global1 from each other connected regional manager.