7.6 Setting the refresh rate for gauges in the Analysis pane
Set the refresh interval (in seconds) for gauges displayed in the Analysis pane as follows:
-
Edit the following file:
Windows: %NNM_PROPS%\nms-ui.properties
UNIX: $NNM_PROPS/nms-ui.properties
-
Look for the following line:
#!com.hp.nnm.ui.analysisGaugeRefreshSecs = 15
Change the refresh interval (in seconds) as follows:
com.hp.nnm.ui.analysisGaugeRefreshSecs = 10
- Important note
-
-
Make sure to remove the #! characters at the beginning of the line.
-
Setting the value to 0 results in gauges never refreshing. A faster refresh rate (for example, faster than 10 seconds) causes some SNMP agents to cache their MIB values for short periods of time, causing repeated results.
-
-
Save your changes.
-
Execute the following commands to restart NNMi:
ovstop ovstart