5.3.3 Configuring node monitoring
If an object does not qualify for any configured interface group, State Poller evaluates the object for membership in node groups. Settings are applied to the first node group match from the lowest ordering number to the highest ordering number.
For each node group, open the Monitoring Configuration form, and then open the Node Group Settings tab. Create a custom set of instructions for how you want State Poller to handle that group. Your instructions can include the following:
-
Enabling or disabling fault polling
-
Setting the fault polling interval
-
Selecting whether NNMi will monitor unconnected interfaces (or unconnected interfaces hosting IP addresses) in the group
You can configure different settings for each interface group.
- Tip
-
Double-check the order numbers, keeping in mind that an object that qualifies for multiple groups has settings applied from the group with the lowest order number.