4.3.1 Configuring community strings
To configure NNMi with community strings, follow these steps:
-
From the workspace navigation panel, select the Configuration workspace.
-
Open the Communication Configuration form, as shown here:
-
On the Default SNMPv1/v2 Community Strings tab, click the New icon.
-
On the Default Read Community String form, in the Read Community String box, enter a community string for one of the nodes in the discovery range, and then click the Save and New icon.
-
Repeat step 4 to enter all community strings for the nodes in the discovery range, and then click the Save and Close icon.
-
On the Communication Configuration form, click the Save and Close icon.
For details about setting up device community strings and loading community strings from a file, see Configuring Communication Protocol in NNMi Help.