10.1 Specifying settings to collect operation logs for storage on a management server
This section describes how to specify settings to collect operation logs from a computer and store them on a management server.
- Important note
-
To collect operation logs, the agent must be installed in advance on a computer from which operation logs are to be collected.
- Important note
-
In a multi-server configuration system, a management server cannot obtain operation logs.
- Tip
-
In the Settings module, select Server Configuration and then the Server Configuration Settings view. In the information area, check that a management server is selected for Operations Log Backup. If a management server is not selected, select a management server for Operations Log Backup.
- Tip
-
If you want to collect operation logs for storage only on a site server, this setting is not required.
To specify settings for collecting operation logs for storage on a management server:
-
In setup, enable Acquisition of Operations Logs.
Specify a folder and the disk space required for storing operation logs. You can also enable or disable automatic backup.
-
In the security policy, specify settings to obtain operation logs.
You can select the type of operation logs to obtain. If you want to detect suspicious operations, you can also specify detection conditions.
-
Assign the security policy to a group or a computer.
The operation logs of a computer to which the security policy has been assigned are collected and stored on a management server.
Related Topics: