KDJH9135-E

The form of the Custom Job definition file is wrong.

(S)

Terminates the processing.

(O)

When this error occurred during the definition of the DH Custom Job after modifying the invalid config.xml, click the cancel button on the Detail Definition - Custom Job window and define the DH Custom Job again.

When you clicked the OK button on the Detail Definition - Custom Job window after this error occurred and created the DH Custom Job, delete the job and define the DH Custom Job again.

With except for the above-mentioned case, if you do not define the job with the following method before executing JP1/DH - AJE (Job Definition), then contact the system administrator.

• As one of the method to define the job, you can register the job by executing the ajsdefine command after you defined the unit in the Unit Definition File. If you registered the custom job of JP1/DH - AJE by this method, remove the error factor after you confirmed the information which contained in the message with the Unit Definition File. In addition, for more information the Unit Definition File, refer to the manual Job Management Partner 1/Automatic Job Management System 3 Command Reference 2.