3.5 Transmitting files
There are two ways to transmit files:
-
Select Card method of file transmission
This method specifies a registered transmission card in the Registration And Execution Of Transmission Requests window and then executes transmission.
-
Enter Information method of file transmission
This method executes transmission without registering transmission information onto a transmission card.
To transmit files, you execute the ftsclient command at the client to open the Registration And Execution Of Transmission Requests window. Alternatively, you can use the ftstran command to specify a transmission card.
- Note
-
Because Linux does not support the ftsclient command, you must use the ftstran command in Linux. Transmission by the ftstran command is applicable only to synchronous execution.
- How to display the Registration And Execution Of Transmission Requests window
-
As an ordinary user, execute the following command:
ftsclient
The Registration And Execution Of Transmission Requests window appears. The following figure shows the Registration And Execution Of Transmission Requests window.
Figure 3‒11: Registration And Execution Of Transmission Requests window