3.4.2 Changing the information registered on a transmission card

You can change the information registered on a transmission card.

This subsection describes two methods, one that uses the Registration And Execution Of Transmission Requests window and one that uses the ftsregc command.

Organization of this subsection

(1) Using the Registration And Execution Of Transmission Requests window
(2) Using the ftsregc command

(1) Using the Registration And Execution Of Transmission Requests window

To change the information registered on a transmission card:

In the Registration And Execution Of Transmission Requests window, select the transmission card to be edited, and then from the Edit menu, choose Change.

The Change Transmission Information dialog box appears.

Figure 3‒10: Change Transmission Information dialog box

Enter new information in the applicable items.
Click Change.

To Page Top

(2) Using the ftsregc command

The following example changes information on a transmission card:

[Figure]

This example changes the following transmission information on card1:

-TC: The card name is card2.
-TH: The connection-target host name is host1.
-TL: The local file name is /temp/file1.
-TR: The remote file name is /temp/file2.

For details about the ftsregc command, see ftsregc - registers, changes, deletes, and displays transmission information in 6. Commands.

To Page Top