3.3 Registering auto-start programs
You can register a program to start at the server after file transmission is finished.
To register auto-start programs, you execute the ftsauto command to open the Auto-Start Program Registration window. Alternatively, you can use the ftsautoma command.
- Note
-
Because Linux does not support the ftsauto command, you must use the ftsautoma command in Linux.
- How to display the Auto-Start Program Registration window
-
For details about the permissions required for command execution, see List of commands in 6. Commands.
Execute the following command:
ftsauto
The following figure shows the Auto-Start Program Registration window.
Figure 3‒2: Auto-Start Program Registration window