3.1 Defining an environment for JP1/FTP
You must specify the environment definition for JP1/FTP at all hosts.
To specify an environment definition, you must execute the ftsdefine command, which enables you to make settings in the Environment Definition dialog box. Alternatively, you can use the ftsutil command.
- Note
-
Because Linux does not support the ftsdefine command, you must use the ftsutil command in Linux.
- How to display the Environment Definition dialog box
-
For details about the permissions required for command execution, see List of commands in 6. Commands.
Execute the following command:
ftsdefine
The following figure shows the Environment Definition dialog box.
Figure 3‒1: Environment Definition dialog box