2.3.3 Setting the language type (UNIX)
This setup need only be performed when you are using UNIX.
You can output messages in English or Japanese. To specify the language type, use environment variable LANG. The following table describes the available character code sets and the values that environment variable LANG may take.
OS |
Available character code |
Environment variable LANG value |
|
---|---|---|---|
HP-UX |
Japanese |
Shift JIS code |
ja_JP.SJIS or japanese |
EUC code |
ja_JP.eucJP or japanese.euc |
||
English |
C |
||
Solaris |
Japanese |
Shift JIS code |
ja_JP.PCK |
EUC code |
ja or japanese |
||
English |
C |
||
AIX |
Japanese |
Shift JIS code |
Ja_JP or Ja_JP.IBM-932 |
EUC code |
ja_JP or ja_JP.IBM-eucJP |
||
English |
C |
- Important note
-
-
If any other value is set for LANG, English is used as the language type.
-
If the JP1/AJS3 for EAP language environment and the SAP BW system language environment do not have the same character codes, information that is obtained from the SAP BW system may be displayed incorrectly.
-