2.2.3 Setting the language type (UNIX)

This setup need only be performed when you are using UNIX.

You can output messages in English or Japanese. To specify the language type, use environment variable LANG. The following table describes the available character code sets and the values that environment variable LANG may take.

Table 2‒5: Available character codes and environment variable LANG values

OS	Available character code		Environment variable LANG value
HP-UX	Japanese	Shift JIS code	ja_JP.SJIS or japanese
		EUC code	ja_JP.eucJP or japanese.euc
	English		C
Solaris	Japanese	Shift JIS code	ja_JP.PCK
		EUC code	ja or japanese
	English		C
AIX	Japanese	Shift JIS code	Ja_JP or Ja_JP.IBM-932
		EUC code	ja_JP or ja_JP.IBM-eucJP
	English		C

Important note

• If any other value is set for LANG, English is used as the language type.

• If the JP1/AJS3 for EAP language environment and the R/3 language environment do not have the same character codes, information that is obtained from the R/3 system may be displayed incorrectly.

To Page Top