KAVV3925-Q
If you run the command by specifying a generic name or the -R option for the unit to be operated on, JP1/AJS3 operation might be affected. Are you sure you want to register the command?
If you use a generic name or the -R option to specify target units, too many units are subject to processing. As a result, the increased load on the network or manager during command execution might affect JP1/AJS3 performance. This message asks you whether you want to register the command as is.
The probable causes are:
-
A generic name is specified for the unit name for the argument of the ajsprint or ajsshow command.
-
The -R option is specified for the argument of the ajsprint or ajsshow command.
To specify a generic name or the -R option, also use the -E, -L, or -T option to narrow down the target units.
- (S)
-
Waits for a response.
- (O)
-
Click Yes to register the command. Click No to cancel.