KAVV3923-E
The execution result of the command cannot be output.
Output file name:file-name
The execution result of the command cannot be output.
The probable causes are:
-
There is a folder that has the same name as the output file.
-
The drive at the output destination does not exist.
-
Another program is editing the output file.
-
You do not have permission to access files in the output folder.
-
The disk does not have sufficient free space.
-
The folder name or file name specified for the output file name contains a colon (:).
- (S)
-
Cancels processing.
- (O)
-
Take one of the following actions according to the cause of the error, and then try the operation again:
-
Change the file name for Output in the JP1/AJS3 Command Entry dialog box.
-
To specify an absolute path, specify the drive at the output destination.
-
If you cannot exit another program because it is editing the output file, change the file name for Output in the JP1/AJS3 Command Entry dialog box.
-
Set the access permissions required for accessing files in the output folder.
-
Allocate sufficient free disk space.
-
Make sure that the specified output file name is correct, and then try the operation again.
-