KAVV400-E
Cannot connect to the connection destination host (host-name) or JP1/AJS3 service on the connection destination host. Detailed information: port-number, IP-address
The host or the JP1/AJS3 service of the host cannot be connected. The probable causes are:
-
The JP1/AJS3 service of the host has not started.
-
The definition of the port number (jp1ajs2monitor) differs from the definition of the port number for the host.
-
The host is not started.
-
The host is in the status in which network connection is impossible.
-
If a firewall is between the system and the host, it does not allow data to pass. For details about the direction in which data passes, see A.2 Directions of traffic through a firewall in the Job Management Partner 1/Automatic Job Management System 3 System Design (Configuration) Guide.
-
If the JP1/Base settings at the connection destination specify the IP binding method on the receiving side for physical hosts, connection was attempted using an IP address that was not bound to a physical host or any logical host.
- (S)
-
Cancels processing.
- (O)
-
Correct the error, and then retry.
If connection was attempted using an IP address that was not bound to a physical host or any logical host at the connection destination, connect with a bound IP address or define jp1hosts or jp1hosts2 information at the connection destination. For details about defining jp1hosts or jp1hosts2 information, see the Job Management Partner 1/Base User's Guide.
Connection may be impossible when the connection destination host is busy. If the target JP1/AJS3 - Manager is connected to more than one unit of JP1/AJS3 - View, specify the retry count. The default is 3.
- How to set the retry count:
-
Create the value DWORD of the name CONN_RETRYCOUNT for the registry key HKEY_LOCAL_MACHINE\SOFTWAER\HITACHI\JP1AJS2V, and set the value for the retry count.